ABS AQ47 Steel Plate – Properties, Chemistry & Equivalents

ABS AQ47 (also written AB/AQ47, ABS Grade AQ47, AQ47 steel plate) is an extra-high-strength steel plate to ABS Rules Part 2, Chapter 1, Section 8 (2018). The number 47 is the yield category (460 MPa minimum, tensile 570-720 MPa) and the prefix AQ sets the Charpy test temperature of 0°C. Grades of this family are supplied quenched and tempered (QT) or thermo-mechanically rolled (TM), and the 43/47 levels may also be normalized or normalized-rolled. It corresponds to grade A460 in IACS UR W16; ASTM A131 does not cover this strength level.

Related grades: ABS DQ47 steel plate ABS EQ47 steel plate ABS FQ47 steel plate ABS AQ43 steel plate.

Gangsteel is specialized in supplying ABS Extra high strength steel plate in ABS Grade AQ47. For more information of Grade AQ47 steel plate, please check them in following:

AB/AQ47  Extra high Strength Chemical Composition in Tempering and Quenching

AB/AQ47

ABS 2022: limits shown are for the quenched and tempered (QT) condition; N/NR/CR and TM supply have different limits in Table 4A. Al/N ≥ 2:1 (not required when other N-binding elements are used); higher C or N may be agreed with ABS; Ni content agreed at qualification; final chemistry must also meet the mill's ABS-approved specification. Product analysis = heat limit ± ASTM A6/A6M Table A permitted variation (band chosen by the specified maximum/upper limit); applies only when product (check) analysis is required; for a range, results may not vary both above and below it. Per ABS Rules for Materials and Welding Part 2 (2022); product analysis tolerances per ABS 2-1-2/5.3 (“chemical tolerances of ASTM A6”) and ASTM A6/A6M 7.2, Table A (also invoked by ASTM A131). Heat limits: ABS 2-1-8/4 Table 4A (2022), QT column.

Crack Sensitivity:  Pcm = (C+Si/30+Mn/20+Cu/20+Ni/60+Cr/20+Mo/15+V/10+5B)%
Carbon Equivalent:  Ceq = 【C+Mn/6+(Cr+Mo+V)/5+(Ni+Cu)/15】%

AB/AQ47 Extra high strength property in tempering and quenching

AB/AQ47

Source: ABS Rules Pt 2, 2-1-8, Table 5A. Either longitudinal or transverse specimens per the order.

Boiler steel plates| Alloy steel plates| High strength plate| Carbon steel plate

If you need more stock steel plates in shipbuilding steel plate, please click warehouse sizes.

 Related steel grades: AB/AH40, AB/AH36, AB/A, AB/B

ABS AQ47 thickness and impact requirements

For ABS AQ47 the Charpy V-notch test is run at 0°C with a minimum average of 46 J longitudinal or 31 J transverse. The requirement does not change with thickness the way it does for hull grades; the maximum thickness depends on the supply condition and the mill approval (ABS 2-1-8, Table 3). Confirm the thickness limit with the mill approval before ordering.

Grades are equivalent in chemistry and properties because the IACS societies use the same unified requirements. A plate still needs a certificate from the vessel's own classification society, so one plate can carry dual or multiple class certification only when each society's surveyor tests it.